YAMAHA: NS1000 Mods C.1992

Please share this...
Share on FacebookTweet about this on TwitterShare on RedditDigg thisShare on LinkedInEmail this to someone

OLC-question-mark

The thread starts: Following a request from another poster I am posting details of the mods that I did to a pair of NS1000's. I actually sold them about 15 years ago so this was quite sometime ago!  My speakers were 1000M’s, but I think my suggestions would work the same for all 1000’s. They are nearly all reversible, unless you cut the original x/over board. I decided to modify the x/overs after reading about the benefits of bi/tri-wiring speakers (each drive unit draws a common voltage, but a bandwidth limited current.)

I also decided that I wanted to put the x/overs as near to the amp as I could, because I had noticed the benefits of shortening speaker cables and wanted to see what the benefit of shortening them to a foot would do (I think the length of the cable post x/over is less important because I believe the amp “sees” the speaker at the x/over.) I started by asking Yamaha for the ...

MORE

===//===

Please click HERE to access the entire VINTAGE archive

  • Please click HERE to access the entire Point Of View archive.
Please share this...
Share on FacebookTweet about this on TwitterShare on RedditDigg thisShare on LinkedInEmail this to someone